Run-Out; Run-Out With Wheels Lifted - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
7.7

RUN-OUT

The run-out procedure is carried out to compensate for any decentring between the plane passing through the wheel and the one
that is actually measured.
This procedure can also be carried out following completion of vehicle diagnostics, by selecting the relative option in the menu (Para.
7.16).
In order to carry out the run-out procedure, it is necessary to have performed the preparation as explained in para. 7.6.2.
7.7.1

Run-out with wheels lifted

2
1
3
1 Flashing of centre keys of sensor head keypads
2 Front left wheel
Rear left wheel
3
Front right wheel
4
5 Rear right wheel
It is advisable to follow the visual instructions that appear on the screen very carefully.
During the initial step, the centre keys of the keypads displayed on the screen will flash, indicating which key needs to be pressed to
start the procedure. It is not necessary to start with a specific wheel or to proceed in a certain order.
The procedure must be carried out on all four wheels. Images of the centre keys of the sensor head keypads flash on the screen,
suggesting that the procedure should be initiated by pressing the specific key.
When the centre key of the keypad is tapped, the following screen appears:
Position indicator
6
7 First point of arrival of rotation
EN-34 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
NOTE: this key can nonetheless be used to skip this procedure, when required.
Current wheel position.
4
5
6
7