Using The Stda30E Clamp; Run-Out For Motor Vehicles With Stda30E Clamp - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
3.7.2

Using the STDA30E clamp

The central crossbar of STDA30E clamps is movable; therefore, it is possible to lower and/or raise the clamp by up to 180 mm if there
is an obstacle (e.g. the truck wheel itself is too wide) inhibiting the communication of the two sensors.
To lower the two sensors to the same level, the crossbar features 3 notches each 60 mm high.
ALWAYS LEVEL THE CLAMP BEFORE LOWERING THE CROSSBAR.
3.7.3

Run-out for motor vehicles with STDA30E clamp

Should the operator wish to use STDA30E truck clamps on a motor vehicle, great care must be taken, because they are much longer
than motor vehicle clamps and, at the end of the run-out procedure and when the wheels are lowered, the clamp may touch the floor,
and therefore move and/or break and compromise the outcome of the next tests.
During the run-out procedure, it is indicated on the screen to turn the wheel, taking the knob as a reference, which is represented by
the red arrow.
By following this method, the run-out procedure would end with the clamp in the vertical position (knob up) and the clamp would
touch the floor when the wheels are lowered.
To avoid this, it is necessary to take as a reference for turning the wheel not the knob but a point on the wheel translated by 90° with
respect to the knob itself, so that the procedure ends with the clamp in the horizontal position.
Reference point indicated on the screen for turning the wheel
1
Position the knob to the right
2
• Turn the wheel by 180° (position the knob to the LEFT). Press the central button on the sensor. Acquire the measurements.
EN-18 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
1 2