Preparing For Measurements; Vehicle Alignment / Direct Measurements - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
7.8

PREPARING FOR MEASUREMENTS

After completing the run-out procedure (Para. 7.7), the vehicle must be prepared for the measurements.
The following screen will appear:
1
3
Unlock the front plates and any rear footboards
1
Brake the wheels with the handbrake and lock the brake pedal with the appropriate tool (this is necessary if steering in order
2
to correctly calculate the camber and caster angles).
Position the front and rear of the vehicle. This procedure is required if the vehicle has previously been raised with the suspension
3
released (e.g. running off-centre with the wheels raised).
7.9

VEHICLE ALIGNMENT / DIRECT MEASUREMENTS

Once the vehicle has been prepared for measurements (Para. 7.8), the following screen appears.
An alignment and levelling procedure for the sensor heads and the resulting direct angle detection must be carried out:
Front left sensor head
level
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
Tap this key to go back to the run-out procedure (Para. 7.7).
Tap this key to continue to the alignment procedure (Para. 7.9).
2
Front wheel alignment
level display.
Front right sensor
head level
2015-M362-0 EN-39