Push Run-Out - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
7.7.2

Push run-out

1
1 Vehicle push direction (back)
Point of arrival of vehicle at 30°
2
It is advisable to follow the visual instructions that appear on the screen very carefully.
• RELEASE the sensor heads so that they are free to oscillate with the movement of the wheel. Wait for the sensor heads to stop
swaying and start moving the vehicle back, very slowly, until the wheel has made a 30° rotation. This rotation can be observed
on the spokes of the STDA35 3-point clamps, as shown below:
Press the centre
key on one of the
sensor heads at
the point of
arrival.
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
Pressing this key on the main screen of para. 7.7.
The following screen appears.
ATTENTION!
This procedure can be carried out correctly only if STDA35 3-point clamps are used, observing a 30°
rotation in accordance with the position of the spokes.
End position (30°
rotation)
2
Initial
position
2015-M362-0 EN-37