Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 144

TABLE OF
CONTENTS
• Mount the rear sensor heads on the 2nd rear axle (the front
sensors are normally illustrated in BLUE, the rear ones in
red).
• Remove the trailer alignment adapter kit
• Press F4 to continue.
Note: The adjustment step for this axle can be skipped by pressing
F2, or all other axles can be skipped by going directly to the final
results page by pressing F3.
• Adjust only the front sensor heads (mounted on the last rear
axle) until they are level and brake them with the appropriate
knobs. Leave the front sensor heads in their position.
• Wait for the next page to be displayed automatically.
• Adjust the "ROTATION" angle referring to the front axle, as
shown in the figure opposite.
• With F3, it is possible to increase and decrease the ROTATION
angle values, as well as to display the toe and camber.
• Press F4 to continue.
• Now adjust the first rear axle as done for the 1st.
• Move the rear sensor heads from the 2nd axle to the 1st,
press F4.
• Level the sensor heads and adjust the SCRUB angle, when
finished, press F4.
Note: The adjustment step for this axle can be skipped by pressing
F2, or all other axles can be skipped by going directly to the final
results page by pressing F3.
EN-62 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86