Viewing The Technical Data Of The Preselected Vehicle - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
Make of the selected
Model of the selected
7.5

VIEWING THE TECHNICAL DATA OF THE PRESELECTED VEHICLE

Once the vehicle has been selected (Para. 7.4.1), a screen appears with the measurements and tolerances of the angles (minimum,
central and maximum value) and other additional data, such as rim diameter, wheelbase, track and any load and tank conditions.
The screen with the measurements and tolerances can be displayed as per the image below: with a single column of corresponding
values for the left and right side.
1
2
3
Any load and tank conditions
1
Wheelbase and track values in mm
2
Circle diameter:
3
Note: it is also possible to change the displayed diameter by pressing on the circle symbol.
Front axle angle tolerances
4
5 Tolerances of rear axle angles
Note: use the scroll to view all the data.
The measurements and tolerances can be displayed as in the screen above: with a single column of consistent values for the left and
right sides.
Alt+F5
EN-28 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
vehicle
vehicle
Pressing this key combo (Alt+F5) displays the measurements with the central value and the overall
tolerance "±".
In the "System configuration" menu (Para. 7.2) it is also possible to set the separate display of left and
right data (some vehicles may have slightly different tolerance values for the left and right sides).
4
5