Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 117

TABLE OF
CONTENTS
At the start of the procedure, a "self-calibration" is performed so that the position indicator is set at the top. As the wheel is rotated
manually, the wheel position is updated in real time on the screen, as is the relative position indicator.
The first goal is to rotate the wheel by approximately 180°, to reach the first highlighted point.
The wheel can be rotated in either direction.
At this point, it is necessary to rotate the wheel until the position indicator is aligned with the second point, positioned at 180° with
respect to the first position and thus coinciding with the starting point.
When the last rotation has been performed, the program acquires the last measurements.
The screen with the "STOP" symbol appears again for about three seconds. After acquiring the measurements, the program automatically
continues and displays the following screen accompanied by a check mark, indicating that for that wheel the procedure is complete.
However, the procedure can be repeated by pressing the centre key of the detection head in question again. When the oscillation
has been performed on all wheels, the programme automatically moves on to the next step.
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
Rotate the wheel by 180° and, once the destination has been reached, tap the centre key on the sensor
head keypad.
The word "STOP" will be displayed for about three seconds, the time it takes for the program to acquire
the measurements.
Rotate the wheel by another 180° and, once the destination has been reached, tap the centre key on
the sensor head keypad.
2015-M362-0 EN-35