Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 152

TABLE OF
CONTENTS
• Install the STDA49N trailer alignment adapter kit, as shown
in the figure.
• Move the front sensor heads onto the STDA49N bar and leave
the rear sensor heads on the rear axle, press F4 to continue.
• Rotate the draw bar until the wheels of the 1st front axle are
aligned, i.e. until the display level appears perfectly centred.
• The F4 key flashes; press it to continue.
• Lock the draw bar and remove the STDA49N trailer alignment
adapter.
• Press F4 to continue.
• Mount the front sensor heads on the 1st front axle again.
• Press F4 to continue.
• Adjust only the sensor heads (mounted on the 1st front axle)
until they are level and brake them with the appropriate
knobs, then wait for the next page to be displayed
automatically.
EN-70 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86