Error Notifications - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS

7.20 ERROR NOTIFICATIONS

This means that a transmission/reception error has occurred due to one or more of the following problems:
• the infrared transceivers of the sensors do not operate
• there is a radio error or interference in the transmission system,
• there is an obstacle (e.g. an open vehicle door) between the front and rear sensors heads
The rear sensor heads are not directly communicating with the cab: their data is transmitted/received via the front sensor heads,
therefore if a front sensor head is not working properly it will be impossible to transmit the data of the corresponding rear sensor
head, even if it is working properly.
If the cause of the malfunction is removed (e.g. the vehicle door is closed), the error page disappears immediately and the measurement
page reappears on the screen. If the problem persists, the system hardware needs to be checked after switching off the equipment
first.
During infrared data measurements, the following screen may appear:
This error page indicates that one or more infrared measurements could not be taken in the horizontal plane. There may be multiple
causes:
• one or more CCD sensors (infrared digital transducer for the measurement of angles in the horizontal plane) are not working;.
• one or more infrared emitters for the measurement of angles in the horizontal plane are not working (I.R. LED)
• there is an obstacle (e.g. an open vehicle door) between the front and rear sensor heads.
If the cause of the malfunction is removed (e.g. the obstacle is removed), the error page disappears immediately and the measurement
page reappears on the tablet.
If the problem persists, the system hardware needs to be checked. To do this, contact technical assistance.
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
During data transmission/reception between the sensor heads and the enclosure, the following screen
may appear.
Red cross near the sensor
head.
Flashing arrows.
2015-M362-0 EN-73