Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 138

TABLE OF
CONTENTS
• Select "Tractor 6x4", for example (6 wheels - 4-wheel drive).
• Press F4 to continue.
• Press F4 to confirm the selected 3-axle tractor.
It is possible to change the rear axle (2nd or 3rd) from which the
adjustment starts to use it as the 2nd axle of the main vehicle.
It is necessary to press F5
Note: it is still possible to change the type of tractor by modifying
the number and the layout of the axles with F2 and F3, or by tapping
the silhouette at the bottom.
• A screen appears with the measurements and tolerances
provided by the manufacturer. The following data refers to
the 1st and last axles.
• Tap the axle in the silhouette in the top left corner to view
the relative data.
• Press F4 to continue.
• An instruction page appears, suggesting the operations to
perform to prepare the adjustment; wait for the next page to
appear automatically or press F4 to continue.
• Mount the front sensor heads on the front axle.
• Mount the rear sensor heads on the 2nd rear axle.
• (the front sensors are normally illustrated in BLUE, the rear
ones in red).
• Press F4 to continue.
Note: the compensation procedure can be performed during the
next step. However, it can be skipped by using the STDA92 clamps.
NOTE: the entire compensation procedure can be disabled
(settings in parameter configuration - Para. 7.2).
EN-56 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
.