Test Drive" Procedure - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
7.15.2

"Test Drive" procedure

NOTE: the possibility to select the "Test Drive" procedure must be set in the "Settings/Procedures" page - Para. 7.2.
1 - Start the vehicle engine
2 - Proceed to settle the suspension clearances, turning the steering wheel a little to the left and right
3 - Turn the steering wheel very slowly until the cursor is exactly in the centre of the alignment level bar
4 - Visually check that the spokes of the steering wheel are positioned correctly in a symmetrical, horizontal or consistent manner
with the straight line of the vehicle.
EN-48 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
Tap this key on the Diagnosis and Adjustment summary page (Para. 7.15). The "Test Drive" (*) procedure
is launched to check the correct adjustment of the partial toes, to check accurate adjustment by
observing the steering wheel spokes.
Tap this key in case of a negative outcome; the program will ask to perform the partial toe adjustment
procedure again, going back to the Alignment step (Para. 7.9).
Tap this key if the steering wheel spokes are correctly positioned; the program will show the following
page.
Turn off the vehicle engine and tap this key to return to the Diagnosis and Adjustment summary (Para.
7.15).