Preliminary Operations; Preliminary Vehicle Check Operations; Run-Out Preparation - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
7.6

PRELIMINARY OPERATIONS

7.6.1

Preliminary vehicle check operations

Before carrying out the vehicle alignment check, it is necessary to perform a number of preliminary checks:
• Check and if necessary eliminate the play on the suspension and on the steering linkage.
• Check and if necessary eliminate possible hardening or yielding of the elastic parts of the suspensions.
• Adjust the tyre pressure to the values prescribed by the manufacturer.
• Position and distribute any loads envisaged by the manufacturer.
7.6.2

Run-out preparation

F4
1
1 Battery charge percentage of rear sensors
Battery charge percentage of front sensors
2
• Prepare for measurements by
blocking the turntables and all the
rear oscillating platforms.
• Put the vehicle in the correct posi-
tion on the lifter, with the front
wheels on the radius indicators.
• Install the clamps and the sensor
heads on the wheels
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
Once the vehicle's technical data page has been viewed (Para. 7.5) tap this key to continue.
The following page appears illustrating the preparation of the vehicle for the run-out procedure.
Tap this key to select the run-out type: with wheels lifted (Para. 7.7.1) or push (Para. 7.7.2).
Note: during this step, the images representing the 4 batteries of the sensors, with their residual charge
percentages, are shown.
2
2015-M362-0 EN-33