Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 140

TABLE OF
CONTENTS
With F3, it is possible to increase and decrease the partial toe
values, as well as to display the total toe and camber.
• Press F4 to continue.
• Tap Shift +F5 to display the partial toe values in zoom mode
and then Shift +F5 again to display them in normal mode.
• Adjust the front axle, the caster, the camber and the toe
where possible and necessary.
• Press F4 to continue.
• Press F2 to repeat the steering procedure or F1 to go back
to the rear adjustment step.
• Move the front sensor heads to the 1st rear axle, press F4 to
continue.
• Important: hold the steering wheel and/or the steering box
still.
Note: The adjustment step for this axle can be skipped by pressing
F2, or all other axles can be skipped by going directly to the final
results page by pressing F3.
• Adjust only the front sensor heads until they are level and
brake them with the appropriate knobs. Leave the rear sensor
heads in their position.
• Wait for the next page to be displayed automatically.
• Adjust the "ROTATION" angle referring to the front axle, as
shown in the figure opposite.
In the example opposite, the 1st rear axle must be rotated
counter-clockwise.
EN-58 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86