Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 146

TABLE OF
CONTENTS
• A screen appears with the measurements and tolerances
provided by the manufacturer.
• The data indicated refers to the 1st and last axles.
• Tap the desired axle in the silhouette in the top left corner to
view the relative data.
• Press F4 to continue.
• Mount the front sensor heads on the 1st front axle.
• Mount the rear sensor heads on the rear axle (the front
sensors are normally illustrated in BLUE, the rear ones in
red).
• Press F4 to continue.
• Turn the steering wheel until the wheels are aligned, i.e. until
the display level appears perfectly centred.
• Adjust the front sensor heads until they are level and brake
them with the appropriate knobs.
• Wait for the next page to be displayed automatically.
• Perform the steering procedure following the indicator on
the screen, first to the left, then to the right, and lastly at the
centre.
• The steering procedure can also be skipped by pressing F4;
in this case, the toe data will not appear.
• Centre the steering wheel and/or centre the steering box.
• Mount the steering support with the special tool.
• Wait for the next page to be displayed automatically or press
F4 to continue.
EN-64 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86