Stda92E Clamps - Dover Vsg Rav.td808 Übersetzung Der Originalanleitung

TABLE OF
CONTENTS
1
1 Reference point indicated on the screen for turning the wheel
2 Position the knob to the left
NOTE:
The clamps must all be placed horizontally when the vehicle is lowered, at the end of the run-out procedure. In this way, during the
sensor ALIGNMENT AND LEVELLING procedure, it will not be possible to level the clamps, but if STDA30E clamps are used (Para.
3.7.1) on a car, it will NEVER be necessary to translate the movable crossbar of the clamp downward because the a car's wheels will
never be so large as to cover the sensors' signal.
3.7.4

STDA92E Clamps

Special truck clamps to avoid compensation, they act on the wheel centre, which is very accurate; excellent measurements are
ensured without the need to lift each wheel.
Each pair of clamps is supplied with 6 short adapters and 6 long adapters.
1 Sensor pin clamping knob
2 Handles for quick clamping on wheel
3 Short adapters
4 Long adapters
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
2 1
3
NOTE:
each clamp has a label with warnings for hands and to refer to this manual before use.
2
2
4
2015-M362-0 EN-19