Dover VSG RAV.TD808 Übersetzung Der Originalanleitung Seite 120

TABLE OF
CONTENTS
• Tap the centre key: the word "STOP" will appear for about three seconds, which is the time it takes for the program to acquire
the measurements, then the program shows the following screen.
Press the centre
key on one of the
sensor heads at
the point of
arrival.
Advance the vehicle once again until the wheel has rotated
another 30° forwards (end point) - the spoke of the clamp is in
the upright position again.
Move the vehicle forward again, until the arrow of the vehicle matches the arrival point (return to the starting position in the centre
of the plates), "STOP" is displayed for a few seconds, the measurements are acquired. The push run-out procedure has been performed.
EN-38 2015-M362-0
RAV.TD808-RAV.TD806 / ROT.SP808-ROT.SP806 / SPA.ART98-SPA.ART86
To repeat the operation, having already advanced in the program, it is possible to return to this page
by tapping this key and then repeat the operations described above.
When the run-out has been performed, the program automatically proceeds to the next step.
"STOP" is
displayed for
about three
seconds.
End position