Requirement Data; Persistent Data - Balluff BIS U-4A7-082-01C-07-S4 Betriebsanleitung

BIS U-4A7-082- _1C-07-S4
Industrial RFID system - Read/write head
8
System integration (continued)
8.3

Requirement data

The device-specific parameters of the identification system
can be parameterized and read out via the ISDU.
The parameter data of the BIS U-IO-Link device are
described in more detail below.
The subindex 0 can be used to address an
entire index. You can therefore reach only the
parameter AutoSelect with Index 0x0088
– Subindex 1, while you can address all
parameters from AutoSelect to
TemperatureAmplifier with Index 0x0088 –
Subindex 0. The arrangement is done in byte
blocks.
8.3.1

Persistent data

The following parameters are stored on the EEPROM and
are therefore still available after a restart or reset.
ISDU – Persistent parameter data
Name
Persistent RFID parameters
Radio profile
Initial Q-value
Max. EPC length
TID length
Session
Trext
Modulation
Read transmitting power
(default)
Autom. increase of
transmitting power on write
Number of repetitions
Active channels
Activate BlockWrite
Max. write length
Max. read length
Automatic scanning
Auto. Scan resolution
28 english
Index Subindex
0x0084 (132) 0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Access Length Data type
R/W 23 bytes Record
R/W 4 bytes UINT32
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 2 bytes INT16
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 4 bytes UINT32
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
R/W 1 byte UINT8
Data Default
Storage
Yes
Yes 0x00000602
Yes 4
Yes 12
Yes 4
Yes 0
Yes 1 (Trext on)
Yes 1 (PR ASK)
Yes 11
Yes 8
Yes 5
Yes 0x0F
Yes 0 (off)
Yes 16
Yes 16
Yes 0 (off)
Yes 50