Ottobock C1000 DS Gebrauchsanweisung Seite 133

NOTICE
Electric interference due to electromagnetic fields. The
power wheelchair has been tested according to EMC reg-
ulations. Take care of the following particularities during
the operation:
The driving characteristics of the power wheelchair can be
affected by electromagnetic fields (mobile phones or other
radiating devices). Please switch off all mobile devices
when driving.
The power wheelchair can generate electromagnetic fields
that can cause interference with other devices. Therefore,
switch off the controls whenever you do not need them.
Despite of compliance with all applicable EMC directives
and standards, the power wheelchair can be affected by
interference from other electric devices (e.g. department
store EAS systems) or cause interference to such devices.
If you notice such a behaviour, move your power wheel-
chair outside the interference range.
INFORMATION
Road traffic regulations must be observed when driving in
road traffic.
C1000 DS
INFORMATION
Every time you switch on the control unit, it will return to the
previously selected speed level. If desired, the starting
speed level can be changed in the parameter settings.
These settings may only be established by personnel that
has been authorised and trained by Ottobock.
INFORMATION
If the driving mode is changed while driving, the power
wheelchair will accelerate or decelerate.
INFORMATION
The control unit of the power wheelchair is protected ac-
cording to protection class IP 54 and the push button mod-
ule according to protection class IPX4. Accordingly both
can be used in bad weather (e. g. rain). The control unit or
push button module is approved for indoor and outdoor
operation and meets the requirements regarding environ-
ment and splashed water.
Safety instructions
Ottobock 133
|