Malfunctions / Troubleshooting - Ottobock C1000 DS Gebrauchsanweisung

8

Malfunctions / troubleshooting

CAUTION
Risk of accidents and injury due to uncontrolled move-
ments of the power wheelchair. Uncontrolled movements
can occur during the operation of the power wheelchair as
a result of malfunctions. In this case, please contact your
authorised dealer immediately.
INFORMATION
During the use of the power wheelchair, electrical dis-
charges may occur which are caused by factors such as
friction (high voltage with low current; discharge via the
user). However, these do not represent a health hazard.
This reduction in comfort – under consideration of the
environmental conditions the user is exposed to – can be
eliminated by custom fabrication measures (installing a
mechanical discharge contact / ground strap to the
wheelchair frame).
Electrostatic discharge may also occur if the power wheel-
chair is equipped with puncture-proof tyres. Retrofitting the
wheelchair with pneumatic tyres can correct this problem.
C1000 DS
INFORMATION
Should you encounter problems while troubleshooting or if
you do not manage to completely eliminate a problem by
following the measures described here, please contact
your specialist dealer.
Malfunctions are indicated on the control panel LCD moni-
tor. Table 6 describes the individual error codes with the
corresponding problem sources as well as the possible
causes and resolutions.
If malfunctions cannot be fully corrected using the proce-
dures described here, an authorized dealer has the ability to
read the exact error code with a handheld programming
device and to carry out a targeted system analysis.
All problems that have ever occurred are saved in a list and
can be retrieved, e.g. in case of a general overhaul of the
power wheelchair. The saved data can be used to deter-
mine future service and maintenance intervals, for example.
Malfunctions / troubleshooting
Ottobock 201
|