Figure 31 Battery Stop - Ottobock C1000 DS Gebrauchsanweisung

WARNING
Risk of tipping due to changing the battery position. En-
sure that the batteries are up against the stop during ins-
tallation and that there is no play between the batteries
and track when installing the track.
NOTICE
Unauthorised battery replacement. Changing the battery
installation location may only be completed by a specialist
dealer.
By default, the batteries in the C1000 DS power wheelchair
are installed in the far forward position. Where required ac-
cording to the indications, e.g. dwarfism, the installation po-
sition of the batteries in the battery drawer must be changed.
Changing the installation position of the batteries shifts the
centre of gravity of the power wheelchair. The driving char-
acteristics of the C1000 DS power wheelchair were tested
with all three possible battery positions and conform to the
test standard requirements in all cases.
Proceed as follows:
1. Turn off the control unit.
2. Remove the fuse (see Section 9.2).
C1000 DS
3. Remove the batteries (see Section 6.6.4)
4. Loosen the two Allen head screws on the stop using an
Allen wrench size 4 and remove the stop.
5. Move the stop according to the mounting bores on the
bottom of the battery drawer and reattach the stop
using the two Allen head screws.
6. Put the batteries back into place.
7. Reinstall the batteries (see Section 6.6.4).
1
Figure 31 Battery stop
1 Mounting holes
2 Allen head screws
3 Stop
Operation
2
3
Ottobock 177
|