Cleaning And Care; Figure 57 Removing The Rear Light; Figure 58 Rear Light Connector Plug - Ottobock C1000 DS Gebrauchsanweisung

Figure 57 Removing the rear light
3. Separate the electric supply line from the connector plug.
Figure 58 Rear light connector plug
1 Plug connection from the rear light to the controller
C1000 DS
4. Remove the rear light.
5. Take the new rear light and connect the electric supply
line to the controller using the connector plug.
6. Position the rear light in the moulding.
7. Insert the Allen head screw and tighten it using an Allen
wrench size 4.
9.5

Cleaning and Care

NOTICE
Risk of damage to electronics due to water penetration.
In order to avoid malfunctions, the electronic components,
motors and batteries must not come into contact with wa-
ter when cleaning the power wheelchair.
NOTICE
1
Risk of damage to power wheelchair components. Do not
use any aggressive cleaners, solvents or hard brushes to
clean the power wheelchair. Never use a water jet or high-
pressure cleaning apparatus to clean the power wheelchair.
Maintenance, cleaning and disinfection
Ottobock 217
|