Figure 10 Loosening The Thumb Screw For Removal; Figure 11 Adapting The Arm Rest To The Upper Arm - Ottobock C1000 DS Gebrauchsanweisung

If the control panel is attached to the arm rest, it must be
removed before taking out the side panel (Section 6.1.4).
Figure 10 Loosening the thumb screw for removal of the side panel
with arm rest
C1000 DS
Adapting the arm rests to the upper arm length
1. Loosen the Allen head screw using an Allen wrench
size 3.
2. Move the side panel with arm rest up or down along
the rail into the desired position.
3. Retighten the Allen head screw.
Figure 11 Adapting the arm rest to the upper arm length
Operation
Ottobock 151
|