Electric Seat Height Adjustment - Ottobock C1000 DS Gebrauchsanweisung

Accessories
NOTICE
Damage due to improper use of the electric seat op-
tions.
n When using electric seat options, note that the seat
function actuators are not designed for continuous
use, only for short-term use under limited loads (10%
load, 90% idle time).
n Observe the following guidelines: At maximum load
capacity, 10 seconds of activation time must be fol-
lowed by approx. 90 seconds of idle time. The electric
seat functions are considered independently of the
driving function for this purpose.
n Only activate the electric seat functions if no fault or
error is present.
INFORMATION
When getting into or out of the power wheelchair, bring
the seat to a level position.
180 Ottobock
|

7.1.2 Electric Seat Height Adjustment

WARNING
Risk of falling due to improper use of the seat height
adjustment feature.
n Drive in street traffic only with the seat height adjust-
ment lowered.
n Use the seat height adjustment feature only with the
backrest in the upright position.
n When driving with the seat height adjustment feature
raised, fasten the belts (lap belt, four-point belt) and
do not lean out beyond the seat surface.
n Ensure that creep speed is activated when the seat
height adjustment function is used. If this is not the
case, contact a specialist dealer immediately. Only
use the power wheelchair with the seat height adjust-
ment in its lowest position until the fault is repaired.
NOTICE
Damage due to lack of maintenance of the seat height
adjustment feature.
n Inspect the seat height adjustment feature for visible
signs of damage at least 1 x per month and ensure all
screw connections are tight.
n Check for correct tyre pressure.
C1000 DS