Ottobock C1000 DS Gebrauchsanweisung Seite 207

Red is flashing 3 x Communication error
Red is flashing 4 x Joystick warning
Brake fault
Red is flashing 5 x
Drive motor fault
Seat function LEDs (see Fig. 40, item 5)
Backrest LED is Back angle adjustment
flashing motor fault
Seat bottom LED
Seat tilt motor fault
is flashing
2 LEDs below
Seat height adjustment
seat bottom are
motor fault
flashing
Backrest / seat
Electric seat function
bottom LED is
temperature warning
flashing
Table 11 Attendant control error messages
C1000 DS
Faulty connection between the hand
control device and controller;
Defective cabling, software or hardware
Joystick is not in zero position when the
unit is turned on
Open brake release;
Defective brake
Faulty cabling or plug connection;
defective actuator
Faulty cabling or plug contact;
Defective actuator
Overheating due to excessive load
Malfunctions / troubleshooting
Check cabling / plug connec-
tions;
Contact specialist dealer
Move the joystick to the zero
position before turning the unit on
Close brake release;
Check brake (e.g. Bowden cable)
Check cabling / plug connections;
Contact specialist dealer
Check cabling / plug connec-
tions;
Contact specialist dealer
Cool down phase
Ottobock 207
|