Moving Up To Position Manually - RK Rose+Krieger RK MultiControl II duo Montageanleitung

6.4.3 Moving up to position manually

Press the "DOWN" key or "UP" key and keep the corresponding key pressed until the
drives have moved to the desired position.
98
• Press the "DOWN" key again and keep it pressed until all drives have
moved to the lower end position or are at the lower end position.
• Press the "UP" key and keep it pressed until the drives have moved to the
upper end position or are in the upper end position.
-›› The LED power indicator lights up green. The initialisation run is
complete. The control is now ready for operation.
Note: If the upper end position cannot be reached or you wish to
configure an upper stroke limit, you can terminate the initialisation run
at any position. To do so, press and hold the "DOWN "key for about five
seconds. This position is the new upper end position for the drives.
MultiControl II duo and MultiControl II quadro assembly instructions