Terminal Assignment - RK Rose+Krieger RK MultiControl II duo Montageanleitung

6.2.2 Terminal assignment

Terminal assignment for MultiControl II duo
1
2
3
4
Terminal assignment for MultiControl II quadro
1
2
3
4
5
6
To connect the drives, please observe chapter „6.3.2 Connecting drives to MultiControl
II quadro".
88
M1 = Drive slot 1
(must always be assigned)
M2 = Drive slot 2
DATA = Interface for
sensors (Safety- edge or similar)
and synchronization- bus
(Sync-BUS)
HS = Hand switch interface
(Control-BUS)
M1 = Drive slot 1
(must always be assigned)
M2 = Drive slot 2
M3 = Drive slot 3
M4 = Drive slot 4
DATA = Interface for
sensors (safety
edge or similar) and
synchronisation bus (Sync-BUS)
HS = Hand switch interface
(Control-BUS)
MultiControl II duo and MultiControl II quadro assembly instructions
Figure 3 - Terminal assignment for
MultiControl II duo
Figure 4 - Terminal assignment for
MultiControl II quadro