Controlling Via The Control Bus; Suitable Drives - RK Rose+Krieger RK MultiControl II duo Montageanleitung

6.6

Controlling via the Control Bus

The MultiControl II duo and the MultiControl II quadro can be controlled via an external control
device (e.g. a PC). The specially designed interface meets the hardware, timing, and check
sum requirements in compliance with the modbus specification. For detailed information on
operation, please consult the separate document which can be made available to you on
request, (for contact information, see chapter 1).
6.7

Suitable drives

There is a list of drives which can be connected to the controller in the table below.
Display
10
11
12
13
20
21
30
35
44
126
Nominal
drive
Multilift I/
Multilift synchro
Multilift II
Multilift II
Telescope
Multilift II
Impact
RK Slimlift
RK Slimlift EM
LZ60P
LZ60S
Drive unit LZ P
Drive unit LZ S
RK Powerlift M
MultiControl II duo and MultiControl II quadro assembly instructions
Resolution
load N Inc/mm
1000 2,000
3000 4,000
1000 26,000
3000 52,000
1000 25,333
3000 52,000
1000 26,000
3000 52,000
1000 10,000
4000 40,000
1000 25,333
1000 8,250
2000 16,500
3000 33,000
4000 58,667
1500 10,000
3000 40,000
4000 71,111
132 Ink/
4 Nm
Umdr.
160 Ink/
5 Nm
Umdr.
1500 26,667
3000 40,000
Speed
Inc/s mm/s
26 13,00
26 6,50
360 13,85
360 6,92
360 14,21
360 6,92
360 13,85
360 6,92
195 19,50
195 4,88
390 15,40
185 22,42
185 11,21
185 5,61
185 3,15
185 18,5
185 4,63
185 2,60
185 1,4015 U/s
185 1,1555 U/s
278 10,43
278 6,95