RK Rose+Krieger RK MultiControl II duo Montageanleitung Seite 123

MultiControl II duo and MultiControl II quadro assembly instructions
Suitable drives") using the "UP" and "DOWN" keys. An initialisation run will be
requested upon confirmation.
The initialisation run must be performed individually for each group.
During this process, each group is moved at the possible nominal speed of
the connected drives and stops separately when reaching the limit switch.
As soon as all groups have successfully completed the initialisation run,
the display switches to "Drive group management" as shown in Figure 20.
Activating drive group management after completing startup:
To configure
after a complete
settings. Press the
the "Control" menu
the function keys and the "UP" and "DOWN" keys. Select the "Reload
factory settings" menu item. After you have reloaded factory settings,
you will arrive at the control's initialisation menu. You are asked
for your preferred language in the display of the hand switch with
6 function keys. Select your preferred language in the display of the hand
switch with 6 function keys. Afterwards, you will be asked if you wish to
perform the initialisation. Press the "M" key to open menu overview. Select
the "Control" menu
the function keys and the "UP" and "DOWN" keys. Select the "Startup"
„Configure drive group management" menu item. After selecting the "Configure
drive group management" menu item, you will be prompted to enter the drive
type for the second group. Configure the correct drive (see „6.7 Suitable drives")
using the "UP" and "DOWN" keys. An initialisation run will be requested upon
confirmation.
The initialisation run must be performed individually for each group.
During this process, each group is moved at the possible nominal speed of
the connected drives and stops separately when reaching the limit switch.
As soon as all groups have successfully completed the initialisation run,
the display switches to "Drive group management" as shown in Figure 20.
the drive
startup, the control
"M" key to
item. Enter
item. Enter
group
must be reset
open menu overview.
the password "13121"
the password "13121"
management
to factory
Select
using
using
→
123