Service View; Service Drive; Options Register Display; Copying Set Of Parameterset - RK Rose+Krieger RK MultiControl II duo Montageanleitung

114

6.5.6.10 Service view

This function graphically illustrates the current consumption of the connected
drives as a bar and as a number in milliamperes. At the bottom of the display,
the stroke is shown in the currently set unit. The "Service view" function serves
to verify the system for possible overloads and distribution of the loads.
To display the
→ "View" menu item. You can only access the menu after entering a password.
You can obtain this password upon request (see chapter 1 for contact information).

6.5.6.11 SERVICE DRIVE

The "SERVICE DRIVE" service function allows one or more drives to
be moved for troubleshooting purposes, even when there is an error.
Another initialisation run will be necessary if this function is executed.
You can only access
can obtain this
contact information).

6.5.6.12 Options register display

You can only access this function in the Premium customised configuration and it
is used to display the activated options of controls with special functions.

6.5.6.13 Copying set of parameterset

With the "Copy parameter set" function, the settings for a MultiControl II duo
or MultiControl II quadro can be copied to one or several other controls with the
same software version.
• Select the "Control → "Parameter"
→ "Copy parameter" menu item.
Afterwards, the display will show
the graphics that you can see in
Figure 16.
MultiControl II duo and MultiControl II quadro assembly instructions
view, select
the menu after
password upon
Figure 16 - Copy set of parameter set
the "Control"→
entering a password.
request (see chapter
"Service
You
1 for