I/O Interface Memory Positions; Displaying The Error History - RK Rose+Krieger RK MultiControl II duo Montageanleitung

112
6.5.6.8

I/O interface memory positions

Seven I/O interface memory positions can be assigned or run to using the hand
switch with 6 functions keys and display.
To be stored, the respective position must first be run to.
Storing a memory position:
• Select the "Control" → "I/O interface memory positions" → "Store
memory position" menu item.
• Set the position to be assigned using the "UP" and "DOWN" keys.
• Confirm the selection.
-›› The position is stored and the display returns to the normal height
display.
Drive to memory position:
• Select the "Control" → "I/O interface memory positions"→ "Drive to
memory position" menu item.
• Use the "UP" and "DOWN" keys to select the memory position which
you wish to drive to.
• Confirm the selection with function key 1.
-›› The position is run to.
• Press function key 2 to leave the menu item.
The memory positions can be run to using the I/O interface, see chapter „6.3.4
I/O interface for MultiControl II duo/quadro".
6.5.6.9

Displaying the error history

The MultiControl II duo and MultiControl II quadro save detected errors in an
internal memory. The last 20 errors that occurred can be shown using a hand
switch with 6 function keys and display.
To view the error history, select the "Control" → "Service" → "Error history"
menu item.
-›› The error history display will open as shown in Figure 14.
MultiControl II duo and MultiControl II quadro assembly instructions