Functions In The Basic Configuration; Setting Up The Stroke Unit/Indicator; Changing The Basic Height; Setting The Upper Stroke Limit - RK Rose+Krieger RK MultiControl II duo Montageanleitung

6.5.6 Functions in the Basic configuration

MultiControl II duo and MultiControl II quadro assembly instructions
6.5.6.1

Setting up the stroke unit/indicator

The factory setting for the height display is specified in percent. The retracted
position is 0%; the extended position is 100%.
Alternatively, the height display can be set to mm, cm, or inches. Select the
→
"Control" "Stroke display"
desired stroke height using the "UP" and "DOWN" keys. Pressing function key 2
takes you one position further to the right. At the last position, you can entered
the desired unit.
6.5.6.2

Changing the basic height

A basic height can be used in a completely retracted drive position, e.g. for
displaying a work surface above the ground.
The basic height function can only be used when the "Stroke unit/indicator" is
set to cm, mm, or inches (see „6.5.6.1 Setting up the stroke unit/indicator").
To configure,
→
"Change basic height" menu item. When the drives are retracted, enter the
height using the "UP" and "DOWN" keys. Pressing function key 2 takes you one
position further to the right.
The height display on the screen shows the sum of the basic height and lift
height.
6.5.6.3

Setting the upper stroke limit

You can set
run or retroactively
→ "Set upper stroke limit" → "Activate" menu item. When activating the top lift
limitation, the current position of the drives is adopted as the top end position.
You can deactivate
→ "Stroke limit" → "Set upper stroke limit" menu item. When deactivating the
upper stroke limit, the top end position determined or set during the initialisation
run is adopted again.
→
"Stroke unit/indicator" menu item. Enter the
select the
an upper stroke
through the
the upper
"Control" → "Stroke
limit during
→
"Control"
stroke limit via
display"
the initialisation
"Stroke limit"
the "Control"
107