Werbung
INSP
ADJ
CONTROL SYSTEM
PERIODIC SERVICE
CONTROL SYSTEM
Steering master inspection
1. Inspect:
Steering master
Excessive play → Replace the bush-
ings.
Refer to "STEERING MASTER" in
chapter 8.
Inspection steps:
Move the handlebar up and down and
back and forth.
Check the excessive play of the han-
dlebar.
Steering cable inspection and adjustment
1. Inspect:
Jet nozzle clearance a, b
Inspection steps:
Turn the handlebar from lock to lock.
Measure clearances a and b.
If clearances a and b are not the
same, adjust them.
2. Adjust:
Steering cable joint 1
(steering column side)
Adjustment steps:
Loosen the locknut 2.
Disconnect the steering cable joint
from the ball joint 3.
Turn the steering cable joint in or out
until
the
obtained.
Turn in
Turn out
3-2
specified
clearance
Clearance a is increased.
Clearance b is increased.
E
is
Werbung
Kapitel
