Werbung
INSP
ADJ
CONTROL SYSTEM
QSTS cable inspection and adjustment
1. Measure:
Nozzle deflector set length a, b
Measurement steps:
Set the jet nozzle in the neutral posi-
tion.
Set the trim grip in the neutral posi-
tion.
Measure
the
length a and b.
If a and b length are not even, adjust
the cable joint.
2. Adjust:
QSTS cable
Adjustment steps:
Set the trim grip in the neutral posi-
tion.
Set the jet nozzle in the neutral posi-
tion.
Remove the nut 1 and pivot pin 2.
Loosen the locknut 3.
Turn the cable joint 4 for adjusting.
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint 4 and pivot
pin 2 and tighten the nut 1.
Tighten the locknut 3.
Locknut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
NOTE:
If correct adjustment by using the cable
joint at the wheel end is not obtained,
adjust the cable joint on the trim nozzle end.
Refer to "REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD" in chapter 8.
3-5
nozzle
deflector
Length b is increased.
Length a is increased.
E
set
Werbung
Kapitel
