Werbung
POWR
INTERMEDIATE HOUSING
1
SERVICE POINTS
Driven coupling removal and installation
1. Remove and install:
Driven coupling
Coupler wrench:
YW-06551/90890-06551
Shaft holder:
YB-06552/90890-06552
NOTE:
Install the driven coupling with the same
special tools that were used for removal.
Driven coupling shaft removal
1. Remove:
Driven coupling shaft
Removal steps:
Temporarily install the driven coupling
to the driven coupling shaft.
Insert the long rod to the driven cou-
pling shaft.
Press out the driven coupling shaft by
pushing the rod.
NOTE:
Support the bearing housing with steel
blocks 1 and press the driven coupling
shaft.
5-41
E
Werbung
Kapitel
