Werbung
INSP
ADJ
POWER UNIT/ELECTRICAL
2. Clean:
Spark plug
(with a spark plug cleaner or wire
brush)
3. Measure:
Spark plug gap a
Out of specification → Regap.
Spark plug gap:
0.6 ~ 0.7 mm (0.024 ~ 0.028 in)
4. Tighten:
Spark plug
Spark plug:
25 Nm (2.5 m • kg, 18 ft • lb)
NOTE:
Before installing the spark plug, clean the
gasket surface and spark plug surface.
Also, it is suggested to apply a thin film of
anti-seize compound to the spark plug
threads to prevent thread seizure.
If a torque wrench is not available, a good
estimate of the correct tightening torque
for a new spark plug is to finger tighten a
the spark plug and then tighten it another
1/4 to 1/2 of a turn b.
ELECTRICAL
Battery inspection
WARNING
Battery electrolyte is dangerous; it contains
sulfuric acid which is poisonous and highly
caustic.
Always follow these preventive measures:
Avoid bodily contact with electrolyte as it
can cause severe burns or permanent eye
injury.
Wear protective eye gear when handling
or working near batteries.
3-12
E
Werbung
Kapitel
