Warnings/Errors In The Electrical Assist System - Orbea Blue Paper Rise Hydro Sl 2025 Bedienungsanleitung

36│ORBEA
3.
Change the assist profiles between BASIC MODE
and FINE TUNEBy default, both assist profiles are set
to BASIC MODE, to add a FINE TUNE setting, select
add a setting in one of the profiles and choose the
setting.
CHANGING THE PARAMETERS OF THE ASSIST LEVELS
(BASIC MODE)
1.
In BASIC MODE, choose the assist level (ECO, TRAIL,
BOOST) and modify its maximum torque, character of
assistance and start of assist parameters. To return to
the default values, position the markers in the position
on the scales with a white dot (Default).
2.
Select Apply to save your changes.
Disconnect the bike from the app by tapping Disconnect.
See the full manual for the Etube Project Cyclist app here:
https://si.shimano.com/es/um/7J4MA
WARNINGS/ERRORS IN THE ELECTRICAL ASSIST
SYSTEM
When an error or warning is detected in the system, LED 1 on
the remote control will flash red. In assemblies with SC-EN600
displays, the error or warning code will be shown on the
display.
Restart the bicycle and connect it to the Shimano Etube Proj-
ect Cyclist app. The identified error and its solution can be
seen in the Maintenance>Error Log section.
You can also refer to the Shimano EP801/EP6 system manual
for information about error codes and their solutions. See the
list of error codes and warnings of the Shimano STEPS system
and their resolution methods at the following link:
https://si.shimano.com/es/error
See how to connect the bike to the Etube Project applica-
tion in the previous section, Selecting assistance profiles.
BLUE PAPER RISE HYDRO SL-LT • 2025
EN