Compatible Garmin Devices. Orbea Rs Toolbox; Orbea Rs Gen2 Batteries; Changing The Assist Level - Orbea Blue Paper Rise Hydro Sl 2025 Bedienungsanleitung

33│ORBEA
The manual for the Shimano SC-EN600 display can be found
here:
https://si. shimano. com/es/manual/search? input_model=
sc-en600

COMPATIBLE GARMIN DEVICES. ORBEA RS TOOLBOX

The Orbea RS Toolbox app lets you display relevant data from
Orbea bicycles with Shimano EP8/EP801/EP6 motors on
your compatible Garmin device, including the charge level of
the battery(ies) as a percentage
See the manual for the Orbea RS Toolbox application for Gar-
min devices at the following link:
Orbea RS Toolbox user manual

ORBEA RS GEN2 BATTERIES

•
Internal battery
The internal battery has no LEDs showing the charge lev-
el. To find out the charge level of the internal battery, it
must be connected to the electrical assist system so that
the charge level can be checked using the methods de-
scribed above.
•
210 Wh Range Extender
Press the main button on the Range Extender battery
once to check the charge level. The LEDs will light up for
5 seconds in 25% segments to show the current charge
level, from right to left.
See the specific section on the Range Extender 210 Wh
RS Gen2 external battery to learn about the charging proc-
ess and displaying the Range Extender's charge level.

CHANGING THE ASSIST LEVEL

SW-EN600-L REMOTE CONTROL
To change the assist mode with the SW-EN600-L lever, press
the X button to increase the assist level to the maximum
available (Boost).
Press the Y button to lower the assist level to the level with-
out electrical assist.
The available assist modes are:
•
OFF (no electrical assist)
•
ECO
•
TRAIL
•
BOOST
When the assist mode is changed, LED2 on the lever will
change colour to show the current assist level. In assemblies
with a display, the name of the current level will be shown on
the display.
The Garmin Orbea RS Toolbox app will also display the se-
lected assistance level on the screen. See the manual for the
Orbea RS Toolbox application for Garmin devices at the fol-
lowing link:
Orbea RS Toolbox user manual
WALK ASSIST
To activate the walk assist mode, press and hold the Y button
on the SW-EN600-L switch unit for 1 second until LED 2
lights up blue on the remote control.
Release the Y button on the remote control and press it again
to activate the walk assist. The system will keep the walk as-
sist activated as long as you keep pressing the Y button on
the remote. While the walk assist is activated, the LED on the
remote control will flash blue.
To cancel the WALK mode, press the X button on the remote
control.
BLUE PAPER RISE HYDRO SL-LT • 2025
EN