Protectors; Chainstay And Motor Protectors - Orbea Blue Paper Rise Hydro Sl 2025 Bedienungsanleitung

71│ORBEA
20

PROTECTORS

CHAINSTAY AND MOTOR PROTECTORS

*
INSTALLING ADHESIVE PROTECTORS: To install adhesive protectors on the frame, first clean the installation area with
isopropyl alcohol (maximum concentration 70%) to remove any dirt or remains of a previous protector. Then remove the adhe-
sive protection from the new protector and install the protector in the appropriate area, pressing on the entire surface to en-
sure that it adapts and adheres well to the contour of the frame.
INSTALLATION OF THE RIGHT CHAINSTAY RUBBER PROTECTOR: If you need to replace the right chainstay rubber pro-
tector, you need to remove the Cable Pass cable routing tube from the right chainstay, as this tube is glued to the outside of
the cable exit hole of the rubber protector. Refer to the Cable Pass tube installation section of this manual for the installation
method.
BLUE PAPER RISE HYDRO SL-LT • 2025
1.
Chainstay rubber adhesive protector
2.
Adhesive foam bottom protector FT
3.
Hinged adhesive foam top protector
4.
EP801/EP6 motor protector
5.
Downtube adhesive transparent protector
EN