Symbol Legend; Safety Instructions - Orbea Blue Paper Rise Hydro Sl 2025 Bedienungsanleitung

7│ORBEA
02

SYMBOL LEGEND

Throughout this manual various symbols are used to detail in-
structions, warnings or relevant information on use, mainte-
nance and assembly. Pay attention to these symbols to avoid
dangerous situations and to ensure the correct use and as-
sembly of all components.
The meaning of these symbols is explained below. In this
manual, the symbol may be accompanied only by the relevant
instruction for the component it describes. Read the following
information carefully to understand its meaning.

SAFETY INSTRUCTIONS

DANGER: Dangerous situation which, if not avoided, will
result in serious injury or death
WARNING: Dangerous situation which, if not avoided,
could result in serious injury or death.
CAUTION: Dangerous situation which, if not avoided,
may result in minor or moderate injury.
Situation not related to physical injury. Relevant
information.
DANGER. RISK OF ELECTRIC SHOCK: Hazardous situa-
tion which, if not avoided, could result in death or serious
injury from electric shock.
WARNING. SHORT CIRCUIT RISK: Not following the in-
structions can lead to short circuits in the electrical com-
ponents, which could cause damage to the components
and fire.
The symbols DANGER and WARNING always imply a risk of
accident if measures are not taken to avoid the situation
they describe. An accident while riding a bicycle can always
involve a risk of serious injury or even death. The risk of
death will not always be repeated in this manual when these
symbols appear, as the risk is detailed here.
BLUE PAPER RISE HYDRO SL-LT • 2025
TOOLS AND TIGHTENING TORQUES
FLAT SPANNER
ALLEN KEY
6
The tool size to
use appears in-
side the symbol
Always use the right tools and products for a specific main-
tenance or repair operation. Unsuitable or poorly maintained
tools, or the use of generic products, may cause damage to
components that are not then covered by the warranty
conditions.
ASSEMBLY COMPOUND
The legend for the assembly compounds to use in a specific
component or area is given in each image related to the as-
sembly of that component throughout this manual.
TORX SPANNER
PHILLIPS
SCREWDRIVER
The indicated tightening
6
torque in Newton.
metres is specified
10 N.m
under the symbol for
the tool to be used.
EN