Orbea BLUE PAPER RISE HYDRO SL 2025 Bedienungsanleitung Seite 65

65│ORBEA
2
3
4
5
INSTALLATION OF THE SL YOKE
In the Rise SL yoke, the bearings are inserted directly into their housing, eliminating the need for cups. Once the bearings are
installed, follow steps 2 and 3 of the LT yoke installation process above to complete their assembly.
2. With the bearings already mounted in the cups, install them on the
yoke, using the specific tool, up to the laser mark (shown in the de-
tailed view).
3. Apply grease to the outside of both bearings and position the seals,
making sure that the flat part of the seal is the one that comes into
contact with the bearing.
4. Place the dust rings in the axle groove, positioning the point to-
wards the external face as shown in the detail view (grease the ring
to facilitate assembly). Apply assembly grease to the body and
head of the thru-axle and medium-strength threadlock to the
threads. Insert it and tighten to the indicated torque (10 Nm).
5. Apply medium-strength threadlock to the pinch bolt threads and
tighten to 1 Nm.
BLUE PAPER RISE HYDRO SL-LT • 2025
EN