Installing Cable Pass Tubes - Orbea Blue Paper Rise Hydro Sl 2025 Bedienungsanleitung

73│ORBEA
2
See the spare parts section of this manual to find the part references.

INSTALLING CABLE PASS TUBES

The installation of the Cable Pass tubes requires advanced mechanical knowledge, since it requires removing the motor and
may require removing the swingarm from the frame's main triangle. Take your bike to an authorised dealer for this type of re-
pair and maintenance. Damage to components caused by incorrect installation is not covered under the guarantee terms.
See the section of this manual covering the removal of the internal battery for the motor removal process to access the mo-
tor housing.
1
Insert the tube for the right chainstay and the left chain-
stay's set of tubes and cable guides through the holes of
both chainstays. The relevant chainstay's rubber protector
must be pre-installed on the chainstay, the Cable Pass tube
is guided through the protector's hole.
6
1
4
5
1.
Cable Pass tube right chainstay
2.
Cable Pass tubes left chainstay and exit port (1 piece)
3.
Rear derailleur housing
4.
Rear brake line
3
5.
EW-SS301 Speed sensor
6.
Cable Pass cable guide
2
Guide the tubes to their corresponding exit (same side) on the
swingarm and motor compartment.
BLUE PAPER RISE HYDRO SL-LT • 2025
EN