Blackmagic Design Cintel Scanner Installations- Und Bedienungsanleitung Seite 95

Lo-Shelf
Low shelf filters boost or cut the target frequency at the low end, and every frequency below it
Hi-Shelf
High shelf filters boost or cut the target frequency at the high end, and every frequency above it
To add EQ to an individual clip:
1 Select the clip in the timeline that you want to add the EQ filter to.
2 Click on the inspector and then click the 'equalizer' enable button.
To add EQ to a track:
1 Double click in the EQ section for one of your tracks in the mixer to open the equalizer for
that track.
2 Select the band filter type from the dropdown menu for the band you want to adjust.
The 6 band parametric equalizer that can be applied to every track
Once you have added EQ to your clip or track, you can adjust the EQ for each band. Note that
controls may vary depending on which band filter type is selected.
To adjust the EQ for a band filter:
1 Select the band filter type from the dropdown menu for the band you want to adjust.
2 Adjust the 'frequency' value to select the center frequency of the EQ adjustment.
3 Adjust the 'gain' value to boost or attenuate the frequencies governed by that band.
4 Use the 'Q factor' value to adjust the width of affected frequencies.
The EQ section in the mixer panel indicating
an EQ curve has been applied to track one
Working with Clips in DaVinci Resolve 95