Blackmagic Design Cintel Scanner Installations- Und Bedienungsanleitung Seite 132

3 Download the latest version of the Cintel Scanner software from the Blackmagic Design
website, install it on your computer and run it. The Cintel Setup utility will detect your
computer is plugged into your Cintel Scanner's USB recovery port. Click 'update now'.
Cintel Scanner software will detect your computer is
plugged into Cintel's USB recovery port
4 After the update recovery is complete, your Cintel Scanner should now be running
the latest software and operating normally. You can check this by disconnecting the USB
cable, connecting the thunderbolt cable, and then power cycling your scanner.
5 Replace the rear panel and reinstall your Cintel Scanner into position for normal operation.
If you need further assistance, you can always visit the Blackmagic Design forum, or reach
us via the Blackmagic Design support center.
Help 132