Blackmagic Design Cintel Scanner Installations- Und Bedienungsanleitung Seite 20

When removing the skid plate you
will need to push the retention levers
down and then turn them outward
To secure a skid plate lift the retention
levers all the way up and turn them inward
Inserting the 16mm Inner Spacer
Insert the rubber 16mm inner spacer at the base of the feeding and taking spools.
The rubber spacer goes on grooved side inwards prior to a backing plate, spool or reel.
Optional Additional Spacers
Additional 1mm rubber spacers are included in the 16mm Gate Kit for when mounting a reel. You
can use these spacers if you need to adjust the alignment of the film with your scanner's rollers.
Mounting your Film
After mounting your 16mm core or reel to the feeding spool, and a backing plate and core to the
taking spool, you'll need to install the outer spacer to secure the spools. This spacer has both a
notch and a rubber ring on its inside edge to secure it to cores or reels, respectively. Once this
is in place, secure the spools as you would normally.
Reel mounting shown from spindle outwards
includes 2 x inner 16mm spacers, 16mm
reel, outer spacer and core clamp
Removing the 35mm skid plate to
install the 16mm skid plate
Core mounting shown from spindle outwards
includes inner 16mm spacer, backing plate,
16mm core, outer spacer and core clamp
Using Your Scanner 20