Blackmagic Design Cintel Scanner Installations- Und Bedienungsanleitung Seite 66

1 To access the rear of the main PCB you will need to remove the rear cover. Using
a T10 driver, unscrew the six countersunk M3 Torx screws and remove the cover.
2 On the rear of the reader, flip the connector latch to disconnect the sub assembly
from the main PCB.
Removing the Sub Assembly
1. Height adjustment removal
3. Mag head arm detachment
1 Gently place the reader onto its back. Remove the two M2 socket head screws from each
side of the height adjustment mount using the HEX 1.5 driver.
2 Using a pair of small tweezers or pliers, carefully remove the E clip. This will allow you
to pull out the clevis pin and detach the arm from the solenoid.
TIP To properly remove the pin, swing the audio arm until the pin can move through
the space between the Collet nut and the solenoid. The collet nut is the nut on the
back of the XLR connector that clamps the cable.
3 Pull the mag head arm sideways to free the sub assembly from the solenoid.
4 Use a 2.5mm HEX driver to remove the M3 shoulder screw.
1
2
3
2. Solenoid E clip and clevis pin
4. M3 shoulder screw
1
4
3
2
4
5. Sub assembly removal
Magnetic Head Replacement
5
5
66