In And Out Controls; Film Controls - Blackmagic Design Cintel Scanner Installations- Und Bedienungsanleitung

Cintel scanner controls in the 'media' page
Transport Controls
The transport controls under the viewer, while similar in appearance to those used while in
playback mode, now work to control the Cintel scanner. Additional controls appear for moving
forward or backward a frame at a time.

In and Out Controls

In Cintel Scanner mode, the 'in' and 'out' buttons to the right of the transport controls define a
range of the film roll from which to capture.
The following groups of settings appear to the right of the 'media' page viewer when in
Cintel Scanner mode to scan clips from film into the media pool.

Film Controls

The film controls provide options to calibrate the scanner's optics, select the film type, adjust
the frame alignment, scan speed and spool wind direction, choose the reel type and turn the
focus assist feature on or off.
Calibration
This option lets you calibrate the optics of the scanner to eliminate optical blemishes or dust
that cannot be removed. Please note that this feature does not remove dust from the film itself.
The 'calibrate' button can be used to help remove dust or small blemishes from the optics of your Cintel scanner
While it's recommended to "spray dust" the optics before scanning new material, it's possible
over time for some blemishes on the optics to be unremovable, in which case using the
calibrate button will eliminate them from the scanned image.
Capturing Using DaVinci Resolve 27