Ic-Fcb-Information - Siemens Simatic Rf600 Projektierungshandbuch

Reader
5.5 SIMATIC RF680R
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
FCC Notice
To comply with FCC part 15 rules in the United States, the system must be professionally
installed to ensure compliance with the Part 15 certification.
It is the responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States. The use of the system in any other combination
(such as co-located antennas transmitting the same information) is expressly forbidden.
FCC Exposure Information
To comply with FCC RF exposure compliance requirements, the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
5.5.9.2

IC-FCB-Information

Siemens SIMATIC RF680R (FCC): 6GT2811-6AA10-1AA0
IC: 267X-RF600R2
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
In order to comply with ISED RF Exposure requirements, this device must be installed to
provide at least 20 cm separation from the human body at all times
To comply with Industry Canada licence-exempt RSS standard(s), the system must be
professionally installed to ensure compliance with IC certification.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio-
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Afin de se conformer aux exigences d'exposition RF ISED, cet appareil doit être installé pour
fournir au moins 20 cm de séparation du corps humain en tout temps.
Pour se conformer aux normes RSS exemptes de licence d'Industrie Canada, le système doit
être installé par un professionnel afin d'assurer la conformité avec la certification IC.
190
Projektierungshandbuch, 04/2024, J31069-D0171-U001-A24-0018
SIMATIC RF600