Ic-Fcb-Information - Siemens Simatic Rf600 Projektierungshandbuch

Reader
5.3 SIMATIC RF615R
Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
FCC Notice
To comply with FCC part 15 rules in the United States, the system must be professionally
installed to ensure compliance with the Part 15 certification.
It is the responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States. The use of the system in any other combination
(such as co-located antennas transmitting the same information) is expressly forbidden.
FCC Exposure Information
To comply with FCC RF exposure compliance requirements, the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
5.3.9.4

IC-FCB-Information

Siemens SIMATIC RF615R (FCC): 6GT2811-6CC10-1AA0
IC: 267X-RF615R
This device complies with Part 15 of the FCC Rules and with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
In order to comply with ISED RF Exposure requirements, this device must be installed to
provide at least 20 cm separation from the human body at all times.
To comply with Industry Canada licence-exempt RSS standard(s), the system must be
professionally installed to ensure compliance with IC certification.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio-
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
146
Projektierungshandbuch, 04/2024, J31069-D0171-U001-A24-0018
SIMATIC RF600