Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 37

Installation instructions, only for experts
Setting the duration of the post-drying program
The maximum duration of the post-drying program is set to 30 min as standard.
If you wish to change this setting, perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "drY" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C:
possible values from "oFF" to "60" minutes (30=standard)
5. Confirm the selection by pressing the On/Off button A.
Querying the software version
To query the software version of your sauna control unit, carry out the following
steps:
1. Open the technician menu (see Page 31).
2. Select "SOC" or "SOP" by pressing the mode button D.
● "SOC" displays the control panel software version (e.g. 202)
● "SOC" displays the power unit software version (e.g. 306)
3. Exit the technician menu by pressing the On/Off button A for about 3 seconds.
Exiting the technician menu
1. The technician menu is closed by pressing the On/Off button for about
3 seconds.
2. Then switch the power unit off for about 10 seconds. (see "Switching off
the power unit" on page 53).
p. 37/62
EN