Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 36

Installation instructions, only for experts
Setting mode of the foil operating mode with temperature regulation
(Pro D2i / Pro D3i only)
Here you can specify that if temperature regulation is set (see "Set operating
mode of auxiliary output-lr" on page 35), the additional output remains in
temperature regulation mode even when the sauna heater is switched on.
1. Open the technician menu (see Page 31).
2. Select "bIr" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "oFF": The additional output changes to intensity mode when the sauna
heater is switched on (standard; dimmable/switchable, see: Page 34)
● "on": The additional output always remains in temperature regulation
5. Confirm the selection by pressing the On/Off button A.
Setting the maximum preset time
The maximum preset time is set to 6 hours as standard. If you wish to change
this setting, perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "tL" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C:
settable values: 6 h (standard) / 12 h / 18 h / 24 h
5. Confirm the selection by pressing the On/Off button A.
Activating the safety shut-off/door sensor
1. Open the technician menu (see Page 31).
2. Select "SdO" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C:
● " SAF" means the safety shut-off is activated (standard)
● "dor" means DOOR - the door sensor is activated
5. Confirm the selection by pressing the On/Off button A.
p. 36/62